Step 2. Step 3. Step 4. Configures a Ten Gigabit Ethernet interface and enters interface configuration mode. Step 5. Step 6. Step 7. The Packet Transport System View dialog box appears. Click the Provisioning tab. Therefore, the destination port or channel group can be any port or channel group on the same card or on different card on the same node. A port on the CPT 50 fanned out from a fabric card can be a destination span port only if the source span port is also on the same CPT A span source port on a CPT 50 fanned out from a line card and a span destination port on another CPT 50 fanned out from another line card is not supported.
If traffic is affected due to this issue, remove the span and reload the line card that has the fanout of the destination CPT 50 span. The operations, administration, and maintenance OAM control traffic is not replicated. The span destination can only be a port or a channel group and not an EFP.
The span source can be a port, channel group, or an EFP. If a channel group is selected as a destination port, the member ports of the channel group cannot be selected as destination ports. The egress span for the line card is supported only for point-to-multipoint traffic.
No service can be associated with the span destination port as well. For port span, two egress span destinations and three ingress span destinations for each card is supported. For EFP span, three ingress span destinations for each card is supported.
When you add the fourth destination port to the span, the traffic is not received on the three destination ports. The maximum egress span bandwidth traffic is 10 Gbps for each card; the maximum egress span bandwidth traffic for the line card is 16 Gbps for the CPT system. If there are multiple source ports, the traffic sent by each source port is not equally shared on the destination port. If QoS policy is attached to a port, span destination port cannot be configured on that.
If a port is FOG port, span destination port cannot be configured on that. Only local span type is supported. Configures an Ethernet service instance on an interface and enters service instance configuration mode. Defines the matching criteria that maps the ingress dot1q, QinQ, or untagged frames on an interface to the appropriate service instance. A port or channel group cannot be specified as a destination port if it carries traffic and has a service ID configured. You can also edit or delete a port or EFP span from the Span tab.
The span type cannot be changed while editing a span. Only the ports in the Permit List tab can be specified as a destination port while creating a span session. If the Permit List tab is empty, all the ports can be specified as destination ports for the span session except the source span ports. Skip to content Skip to search Skip to footer.
Book Contents Book Contents. Find Matches in This Book. PDF - Complete Book Updated: February 11, Chapter: Configuring Span. The standby fabric card becomes active and the software MAC address table on the new active card is used. The standby fabric card is reset. The standby fabric card is updated with the software MAC address table during the bulk synchronization process.
The line card comes up after the line card is reset soft reset. The active fabric card sends the MAC addresses learned on the bridge domains that are configured on the line card. This procedure enables or disables MAC learning on a bridge domain. You have completed this procedure. MAC learning is enabled on the point—to—multipoint bridge domains by default.
Step 1. Enables privileged EXEC mode. Enter your password if prompted. Step 2. Step 3. Configures components on a bridge domain and enters bridge domain configuration mode. Step 4. Step 5. Step 6. Exits bridge domain configuration mode and returns to privileged EXEC mode. Step 7. From the View menu, choose Go to Home View.
Click Carrier Ethernet. Click Edit. The Edit Circuit dialog box appears. Click the MAC Learning tab. Click Apply. Return to your originating procedure NTP. The maximum MAC address limit on a bridge domain is This procedure configures MAC address limit on a bridge domain.
0コメント